Titanium Dioxide Production 250litr 75 KW Non Explosion Wet Milling Equipment For Higher Quality And Performance
This series and models Wet Milling Equipment are widely used in Titanium Dioxide Production , have more than 28 years experience and the performance and efficiency of 2 sets series are better than 1 set cirlulation.
The main introduction of Wet Milling Equipment
Main composition: 6 main system structures.
Core components: double end mechanical seal with patent. highly resistant to over 1600 kinds of solvents.Dfferent choices for industries with various chamber materials
Wet Milling equipment of performance:
- Higher cooling control system to lessen temperature
- better grinding fineness according to considerations of specified conditions
- better grinding output 15-30% with static large flow screen ring
- better to less labor cost with alarming system
The SP250 Wet Milling Equipment main parameter:
| NO. |
Main parameter |
SP250 |
Note |
| 1 |
Motor power (kW) |
75 |
3phase,380V 50Hz |
| 2 |
Effective Volume
(L)
|
250 |
|
| 4 |
Water presure Mpa |
0.3 |
|
| 5 |
Cooling water consumption
(L/min)
|
2.5 -3m3/h
|
The lower limit can be
selected for the water consumption, in case that the cooling water temperature is lower than 10℃.
|
| 6 |
Overall dimension (mm) |
2200*1000*1950 |
|
| 7 |
Weight (kg) |
2300 |
|
The advantages of SP250 Wet Milling Equipment
1 .mechanical seal:
It has 2 patented technologies, with forced coolant, sealing ring resistant to 1600 kinds of solvents, coolant is compatible with materials, no pollutants, reliable operation.
2 Discharge separation system:
Large flow, nonclogging: dynamic hollow rotor-super large area slot cylinder separator uses dynamic centrifugal force separation principle.Use of extremely small grinding beads ( 0.3 to 3 mm).No export blockage occurs under high flow conditions. Good heat dissipation, narrowest particle size distribution.
3. Grinding inner chamber :
It has two patented technologies: chamber cooling and disassembly. The chamber volume is from 0.6-300L. The materials are stainless steel, alloy steel, ceramic, hard alloy, polyurethane, etc.
The Customers site show:
The After sales service:
1. Video instructions for installation and commissioning, if need, we will arrange engineer to your factory.
2. 12-24H feedback any customers questions, firstly offer the video help you solving, if need arrange maintenance engineer for you.
The package and shipping: Be covered with anti-abrasion film and then packed in wooden boxes, then seashipping by FCLor LCL.
Also offered the related products: Dispersing machine & the Zirconical beads, This 2 products are much important for the Bead mills, this materials is pre-dispersing well, It's better for grinding with bead mill after pre-dispesing well. Also the zirconia beads (grinding beads with different size for meeting different finally fineness.
If need more detailed information, please don't hesitate contact us, Also Warmly welcome to visit us.
Your message must be between 20-3,000 characters!